Installing a DIMM
|
CAUTION: To avoid damage to the hard drives, memory, and other system components, the air baffle, drive blanks, and access panel must be installed when the server is powered up. |
Before installing a DIMM, you must remove any previously installed WS460c Graphics Expansion Blade access panel and blade.
To install a DIMM:
- Power down the server.
- Remove the workstation blade.
- Remove the access panel.
- Remove all DIMM baffles.
- Open the DIMM slot latches.
- Install the DIMM.
- Install all DIMM baffles.
- Install the access panel.
If you are installing DIMMs in a mirrored or lock-step configuration, configure this mode in RBSU.
If necessary, reinstall the WS460c Graphics Expansion Blade and the access panel.